Level 2

Posted on April 10, 2018| By

1. Engine: Cylinder block, cylinder head and all internally lubricated parts; intake manifold, exhaust manifolds without internal catalytic converter; water pump, harmonic balancer and its bolt and pulley; valve covers, timing cover, timing belt and tensioner, timing chain, and gears; oil pump cover, gears, pressure relief valve, pickup and screen; oil pan, internal fasteners, engine mounts, flywheel, turbo/supercharger and waste gate; seals and gaskets for listed parts.
2. Transmission: Transmission/transaxle case and all internally lubricated parts; extension housing, transfer case and all internally lubricated parts; torque converter, valve body, transmission pan, viscous coupler, shift linkage, bell housing, electronic shift control unit and solenoids; flex plate, ring gear, transmission mounts; seals and gaskets for listed parts.
3. Drive Axle: Differential housing and all internally lubricated parts; differential cover, front and rear wheel drive axle shafts; constant velocity joints and boots, universal joints, four wheel drive engagement actuator, four wheel drive locking hubs, drive shafts, center support and bearings; drive shaft yokes; seals and gaskets for listed parts.
4. Additional Hybrid/Plug-In Electric Components: Electric motor/generator(s) all internal components; inverter/converter/transformer united including all internal components; reduction/reducer box and all internal components; seals and gaskets.
5. Brakes (ABS and Non ABS): Master cylinder, wheel cylinders, vacuum and hydraulic brake boosters, metal hydraulic lines and fittings, calipers, backing plates and hardware, proportioning and combination valves, brake pedal assembly, electronic brake control unit, wheel speed sensors, pressure modulator control/isolation dump valves, high pressure hydraulic pump, solenoids, accumulator; seals and gaskets for listed parts.
6. Air Conditioning: Condenser, compressor, evaporator, expansion valve, orifice tube, clutch, coil and pulley; idler pulley and bearing; receiver dryer, o-rings, oil and refrigerant (when required with a covered repair due to leaks); manual climate control head, hi-low pressure cut off / cycling switch, A/C hoses and lines; seals and gaskets for listed parts.
7. Steering: Steering gear housing and internal parts; power steering pump, its internal parts and reservoir; rack and pinion housing and internal parts; power steering hoses, steering column shaft, couplings and bearings; pitman arm, idler arm, tie rod ends, center link; seals and gaskets for listed parts.
8. Suspension: Upper and lower control arms, shafts and bushings; stabilizer bars, bushings and links; torsion bars and their mounts and bushings, radius arms and bushings, strut bars and their links and bushings; spindle, spindle support and steering knuckle; ball joints; seals and gaskets for listed parts.
9. Fuel: Fuel pump (mechanical or electrical), fuel pump relay, fuel distribution rails, fuel level sending unit, lift pump; seals and gaskets for listed parts.
10. Electrical: Alternator, voltage regulator, starter motor and solenoid; front and rear wiper motors; wiper motor relays and delay switch/module; washer pumps and switches; back up light switch, stop lamp switch, neutral safety switch, glove box light switch, courtesy light and door jamb switches, ignition switch, ignition lock cylinder and any electrical switch that is physically touched by a Vehicle occupant to activate an accessory.